After reading your answer to a similar question, I feel confident that I.

The first and easiest way to obtain cuttings from your Rubber Tree is to create stem cuttings from your plant. For this, you would be removing about six inches from the tips of the actively growing branches and using those pieces to propagate new plants. Aug 08, Propagate a Rubber Tree Plant with Cuttings. Rubber tree plants can grow very tall and this means an indoor rubber tree occasionally needs to be pruned. After pruning, don’t throw out those cuttings; instead, use them to propagate a rubber tree plant.

Propagating a rubber tree plant from cuttings starts with getting a good cutting. The cutting should be about 6 inches (15 cm.) long and have at least two sets of leaves. The next step in how to start a rubber tree plant from cuttings. Jul 24, Prune rubber tree plant by making your cuts just above a node– where the leaf attaches to the stem or where another stem branches off.

You can also prune just above a leaf scar. Remove about a third to one-half of the plant’s branches but take care not to Estimated Reading Time: 2 mins. There are two cutting techniques that work for propagating rubber trees: basic stem cutting and leaf bud cutting. Each requires the same set of tools and supplies. Sterilize a sharp knife in 1 part bleach mixed with 3 parts water. Soak the knife in the solution for five minutes, rinse it with clean water and allow it.

Jul 22, How to Cut Back a Rubber Tree Plant That Is 10 Feet Tall 1. Remove any dead, dying or damaged leaves or branches.

Propagation with tip cuttings has a high casualty rate.

Cut them off flush with the lateral branch or stem. 2. Cut off any shoots that seem to be sticking out excessively in order to shape the outer perimeter of the rubber tree.